Contn:
Remove 2 screws fixing the door lock.
Push it down and remove the front panel.
Remove 4 screws fixing the panel
Remove the sub seal connector, which is attached to the detergent drawer housing.
Remove the wire that connected to the valve.
Remove the valve connection.
Remove detergent drawer housing ass'y.
Remove the wire that connected to parasite filter.
Remove the power cable group as it is showing the picture.
Remove the wire that connected to pressure switch.
Remove the pressure switch as it is showing the picture.
Remove the pressure switch hose handcuffs and pressure switch hose as it is showing the picture.
Remove one screw fixing the door cover.
Remove the wire that connected to the door lock.
Remove pipe clip that fixes the drain hose.
Remove the pipe clip fixing the tub outlet hose.
Remove the wire that connected to the pump motor.
Remove 4 screws fixing the pump motor.
Remove the wire that connected to resistance.
Remove one nut fixing the resistance.
Remove 4 screws fixing the front counterweight on the front and pull it up.
Hold the gasket and gasket body fixing spring together, and pull them up.
Remove 2 pim fixing the shock absorber.
Remove four screws fixing the spring hanger sheet iron.
Remove the washing group as it is showing the picture.
Remove 3 screws fixing the upper counterweight.
Remove the belt as it is showing the picture.
Remove one screw fixing driven pulley.
Lay down the machine with an angle of 45 Degree to the floor. Disconnect wires and remove 2 screws fastening the motor under the tub. Pull the motor for disassembley.
Remove the 17 screws fixing tub.
ERROR CODES
|
Failure code.
|
Failure indicator.
|
Probable failure.
|
|
Err 1
|
The start/pause
light
blinks
|
The door is not
shut
properly.
|
|
Err 2
|
The program
ready light
blinks.
|
The water level
in your machine
is below heater.
The pressure of
your water
supply may be
low or
locking.
|
|
Err 3
|
The start/pause
light and
program ready
light
blinks .
|
The pump has
failed or the
pump filter is
obstructed.
|
|
Err 4
|
The program
end light
blinks.
|
There is an
excessive
amount of water
in your
machine.
|
|
Err 5
|
The start/pause
light and program
end light
blink.
|
The heater of
your machine or
the heat sensor
has
failed.
|
|
Err 6
|
The program
ready light and
program end light
blink.
|
The motor has
failed.
|
|
Err 7
|
The start/pause
light,program
ready light and
program end light
stays on
permanently.
|
Configuration
error.
|
|
Err 8
|
The start/pause
light,program
ready light and
program end light
blink.
|
The motor has
failed.
|
|
Err 9
|
The program
ready light and
program end light
stays on
permanently.
|
The network
voltage is too
high or
too low.
|
