[1]
TO ENTER SERVICE MODE
Press [Mute => 1 => 8 => 2 => Power On] buttons in series by the remote control.
Initial display when the Service Mode is switched ON
----------------------------------------------------------------------------------------
- DPP1010 (ALL)
- DNle (ALL)
- AD9883 [COMPONENT / 480p]
- VPC3230 [RF / VIDEO / 4801]
- JAGADC [PC]
- FLI2300 [RF / VIDEO / 4801]
- 3D_COMB [ALL]
- OPTION
RELEASE TIME SW Version
------------------------------------------------------------------------------------------
Service Mode Control Keys
- Channel Up / Channel Dn => Select item by moving cursor.
- Volume Up / Volume Dn => Increase or decrease the data value to selected item.
COMMON FAULTS
- When the domestic Power LED indicator does not light up =>
- Check whether or not the power cord is connected.
- Check whether the power switch on the right side of the set has been pressed.
- Check the Line Filter Fuse.
- Check connectors of the analog [CN111 & CN511] connectors.
- Check the connection of the Digital CN307 connector and check whether the LED indicator OP301 (one) is lit.
- Check the connection of Digital CN303 connector and check whether [5V] power has been supplied to Pin-5.
=======================================================================
- When the abnormal Temperature Indicator LED is lit or flickers =>
- Check whether the temperature sensor connector attached to the engine has been inserted normally into CN305 on the Digital Board.
- Check whether the temperature sensor is normal when both terminals has been short circuited: (connected).
=======================================================================
Timer + Standby LED blinking at abnormal temperature. Power LED blinking at abnormal temperature =>
- Check that the fan operates when LED for timer, standby or abnormal temperature blinks.
- Check that the cover detection switch is inserted at CN310 on Digital board when LED for timer, standby or abnormal temperature blinks.
- When LED for timer, standby or abnormal temperature blinks, check that the lamp cover is properly assembled and that the switch pressing boss (inside) is not bend.
========================================================================
Contd: