SONY TRINITRON - KV-32HS500_KV32HV600_ BLINKING CODES _ SELF DIAGNISIS

 [DA-4 CHASSIS]


APPLICABLE TO:  SONY TRINITRON - HS_HV_DRC & XBR SERIES MODELS 


     When an error occurs, the Standby/Timer LED flash a set number of times to indicate the possible cause of the problem.  If there is more than one error, the LED will identify the first of the problem areas.

     Results for all the following diagnostic items are displayed on screen.  If the screen displays a [0] an error has occurred.

#  If +B over current is detected, stoppage of the vertical deflection is detected simultaneously.  The symptom that is diagnosed first by the micro-controller is displayed on the screen.

##  If Standby/Stereo LED flashes (6) times, unplug the unit and wait 10 seconds before performing {G2} voltage adjustment.

----------------------------------------------------------------------------------------------------------------------

Diagnostic Item	No. of times Standby|Timer lamp flashes	Display result	Probable cause location	Detected symptoms
Power does not turn ON	Does not light	==========	[1] Power cord is not plugged in. [2] Fuse is burned out (F501: A board)	* Power does not come ON. ** No power is supplied to TV.  *** AC power supply is faulty
+B Overcurrent (OCP)	2 times	2:0 or 2:1	[1] H-Out (Q5030) is shorted. (D-board) [2] +B pWM (Q5003) shorted [d board]	* Power does not come On.  ** Load on power line is shorted.
Low +B voltage (OVP)	3 times	3:0 or 3:1	IC 6505 is faulty. [D board]	Has entered standby mode.
Vertical deflection stopped.	4 times	4:0 or 4:1	* 15V is not supplied. [D board].  ** IC 5004 is faulty. [D board]	*  Has entered standby mode after Horizontal raster. ** Vertical deflection pulse is stopped. *** Power line is shorted or power supply is stopped.
White Balance failure	5 times	5:0 or 5:1	* Video out (IC9001 – IC9003) is faulty. [ch,cx board]. ** CRT drive IC (IC2801) is faulty [B board].  *** G2 is not properly adjusted.	* No raster is generated.  ** CRT cathode current detection reference pulse output is small.
Low +BOCP/OVP [Over current/Over voltage.	6 times	6:0 or 6:1	+5V line overloaded. (A,B of M) boards)  ** +5V line is shorted. (A,B of M boards). *** IC504 is faulty (A board).	No picture
Horizontal deflection stopped	7 times	7:0 or 7:1	==========	No picture