LG - DP-3514 _ DP-2514 _ STARTING AND SHUTTING DOWN THE PROJECTOR.

• Connect the power cord to the projector and then to AC wall socket.  The 'Power' and 'ready' LEDs on the projector will light.
• Turn 'ON' the connected devices.
• Ensure the Ready LED displays a solid orange, and not a flashing orange.  Press the 'Power' button to turn ON the projector.  The projector splash screen displays, and connected devices are detected.  See Setting an Access Password (Security Lock) is enabled.

• If more than one device is connected, press the 'Source' button and use [Up | Dn] to scroll among devices.

• When the "Power Off / Press Power again" message appears, press the Power button.  The projector turns OFF.
• Be sure to remove the lens cap before starting projector.
• do not plug the Power Cord, until the lamp LED stops (on Cooling mode) flashing-indicating  the projector has cooled down.

SETTING AN ACCESS PASSWORD.

• Can use four arrow buttons to set a password, and prevent unauthorized use of the projector.   When enabled, the password must be entered after power ON the projector.  KEEP the PASSWORD in a SAFE PLACE.  Without password, it will not be able to use the projector, and if password is lost, have to  contact the reseller for further information.

1. Press 'Menu' button to open the OSD menu.
2. Press [ > \ < ] button to move to installation I Menu

3.  Press the cursor [Up | Dn] button, to select Security Lock.

4.  Press [< \ > ] button to enable or disable security lock function. A password dialogue box will automatically appears.

5.  Use [< \ >] {Up |Dn} buttons, either on the keypad or on the remote control for password entry. Can use any combination including the same arrow 'Five' times, but not less than 'Five'.  Press the cursor button in any order to set the password.  Select 'Menu' to Exit the dialog box.

6.  Password confirm menu appears when user press the Power On key, in case the security lock is enabled.  Enter the password in the order you have done earlier. In case, the password has lost, there is no other way than contacting the SG Service Center.