PHILIPS - 37PFL 5603D _ LED BLINKING CODES_ERROR CODES

LED BLINKING CODES

     To activate, enter SDM or CSM.  The blinking front LED will show the entire contents of the error buffer.

     Transmit the commands "Mute" - "062500" - "OK" with a normal remote control.  The complete error buffer is shown.  Take notice that it takes some seconds before the blinking LED starts.

     Transmit the commands "Mute" - "06250x" - "OK", with a normal remote control; where 'x' is a number between '1~5'.  When 'x'=1, the last detected error is shown.  x=2, the second last error, etc.....  Take notice that it takes some seconds before the blinking LED starts.

     When the blinking LED procedure is activated in the "ON" state, the front LED will show [blink] the contents of the error-buffer.
Error codes > 10 are shown as follows.

1. 'n' long blinks [where 'n'=1~9], indicating decimal digit,
2. a pause of 1.5s,
3. 'n' short blinks [where n=1~9],
4. a pause of ~ 3s,
5. When the error codes are displayed, the sequence fininshes with a LED blink of 3s,
6. The sequence starts again.

Example: Error 12 8 6 0 0.

After activation of SDM, the front LED will show:

1. 1 long blink of 750ms [which is an indication of the decimal digit], followed by a pause of 1.5s,
2. 2 short blinks of 250ms followed by a pause of 3s,
3. 8 short blinks followed by a pause of 3s,
4. 6 short blinks followed by a pause of 3s,
5. 1 long blink of 3s to finish the sequence,
6. The sequence starts again.

Error	Description	Error/Prot	Detected by	Device	Result
3	IIC3	E	MIPS	PNX85xx	Error logged
5	PNX85xx doe not boot [HW cause]0	E	Standby P	/	Protection + Error blinking
8	1V2, 1V4, 2V5, 3V3	P	Standby P	/	Protection + Error blinking
9	Supply fault	P	Standby P	/	Protection + error blinking
11	IIC-MUX1	E	MIPS	PCA9540	Error logged
12	IIC-MUX2	E	MIPS	PCA9540	Error logged
23	HDMI mux	E	MIPS	AD8190 / AD8191	Error logged
24	IIC switch	E	MIPS	PCA9540	Error logged
26	Master IF	E	MIPS	PCA9898 /9897 /84C7N	Error logged
28	MOP [ambilight MOP on DFI panel]	E	MIPS	EP2CXXF484C7N	Error logged
34	Tuner	E	MIPS	TDA1716	Error logged
37	Channel decoder	E	MIPS	TDA10060 / TDA10048	Error logged
46	Pacific3	E	MIPS	T6TF4	Error blinking _ Error logged
53	PNX85xx does not boot [SW cause]	E	Stby P	PNX85XX	Error blinking
63	Power ok	E/P	MIPS	/	Error logged in case of a PDP set.  Protection in case of an LCD set.
65	DFI [EPLD on DFI panel]	E	MIPS	/	Error blinking + error logged.