PHILIPS - BELT - LC7.2E _ CHASSIS _ LED BLINKING CODES

     Errors can be displayed by the blinking LED procedure.  The method is to repeatedly let the front LED pulse with as many pulses as the error code number, followed by a period of 1.5 seconds in which the LED is “off”. Then this sequence is repeated.

Example (1): error code 4 will result in four times the sequence LED “on” for 0.25 seconds / LED “off” for 0.25 seconds. After this sequence, the LED will be “off” for 1.5 seconds. Any RC5 command terminates the sequence. Error code LED blinking is in red colour.

Example (2): the content of the error buffer is “12 9 6 0 0” After entering SDM, the following occurs:

• 1 long blink of 5 seconds to start the sequence,
•  12 short blinks followed by a pause of 1.5 seconds,
•  9 short blinks followed by a pause of 1.5 seconds,
•  6 short blinks followed by a pause of 1.5 seconds,
•  1 long blink of 1.5 seconds to finish the sequence
• The sequence starts again with 12 short blinks.

DISPLAYING ENTIRE ERROR BUFFER

the entire error buffer is displayed when Service Mode “SDM” is entered. In case the TV set is in protection or Stand-by: The blinking LED procedure sequence (as in SDM mode in normal operation) must be triggered by the following {RC sequence: “MUTE” “062500” “OK”.}

In order to avoid confusion with RC5 signal reception blinking, this blinking procedure is terminated when a RC5 command is received.

To erase the error buffer, the RC command “MUTE” “062599 “OK” can be used.

Error code	Description	Item nr.	Remarks
0	No error
1	DC protection of speakers.
2	+12 protection error.		12Vmissing or Low.
3	Reserved
4	General I2C error
5	Trident video processor communication error.	7202	When Trident IC is defective, error 10 and 14 might also be reported. Trident communicates via parallel bus, not via the I2C bus. The I2C bus of Trident is only used in ComPair mode
6	I2C error while communicating with the NVM	7215	The TV will not start-up due to critical data not available from the NVM, but the LED will blink the error code
7	I2C error while communicating with the tuner.	1101
8	I2C error while communicating with IF demodulator	7113
9	I2C error communicating with the sound processor.	7411
10	SDRAM defective	7204
11	I2C error while communicating with HDMI IC	7817
12	I2C error while communicating with the MOJO PNX8314	7G500	If applicable.
13	DVB HW communication error	7F01 7K00 7G00	If applicable
14	SDRAM defective	7205
15	Reserved
16	Reserved
17	Reserved
18	I2C error while communicating with the iBoard processor		If applicable
19	I2C error while communication with 1080p bolt-on module		If applicable

• Some of the error codes reported are depending on the option code Configurations.
• This error means: no I2C device is responding to the particular I2C bus. Possible causes: SCL/SDA shorted to GND, SCL shorted to SDA, or SCL/SDA open (at uP pin).  The internal bus of the Trident platform should not cause the entire system to halt as such an error can be reported.