Note: When all batteries are
disconnected, the BIG BUTTON™ retains it’s settings for a few hours. Should you
fail to replace the batteries in time, you may have to reprogram.
PROGRAMMING METHOD
- {MODE (3 sec) → digit→ digit→ digit.}
- {e.g. for a Zenith TV, press and hold "TV" button until LED starts blinking, then press and release "0", "6", "9"}
DETAILS
Referring to the DEVICE CODE LIST,
look up the 3-digit Code Number that corresponds to the brand and models of
your equipment. If there is more than one DEVICE CODE listed under your brand,
try the first code with the following instructions:
- Hold down the Device Mode Button (e.g. TV) until the status LED indicator (located above the "ON/OFF" button) begins to blink. (This takes about 3 seconds) Then release the button.
- Enter the three digit code of the DEVICE from step “l” above. Upon entry of the third digit, the status indicator will blink a confirmation (3 blinks) if the code was accepted, but will turn OFF immediately if the code was rejected. If rejected, try another code.
Try the functions on the BIG
BUTTON™. If your device responds to your requested function correctly, you have
entered the correct Code. Otherwise, repeat the above setup instructions with
the remaining Device Codes until your device (e.g. TV) responds to your
requested function. Simply repeat the above procedures to enter the Device Codes for your VCR, CBL/SAT, DVD or TIVO
(Remember to press Device Mode Button TV, VCR, CBL/SAT or DVD in step 2 above).
POWER SCAN SEARCH FUNCTION
- If you cannot find a correct Device Code for your equipment, see USING POWER SCAN (searching) section .
- Manually turn on the device you wish to scan for (e.g. TV).
- Perform Power Scan by pressing and holding (approximately 3 seconds) the desired DEVICE MODE button TV, VCR, CBL/SAT or DVD until the status indicator light begins to blink.
- Press and release the ON/OFF(power) button. The status indicator light will stop blink ing and stay ON at this point.PRESS and RELEASE slowly and patiently the blue [UP] button to scan forward through the code database. To scan backward through the code database, press and release the blue [DOWN] button. Each time you press the up or down arrow, the remote will try and turn off the device (TV, VCR etc) you originally selected.
- When the device (TV,VCR etc.)
responds by shutting off, press the ENTER button. This will store the code in
memory and you will see three blinks of the status indicator light to confirm
the code input. Be
patient, there are over 100 codes to search through.
NOTE:
Power Scan Model Check is the same
as Power Scan, however, other keys may be tested to see if they work with the
target device without leaving the scan feature. If the device responds to the
other keys pressed, then the current ID will be locked in by pressing the ENTER
button. Otherwise, scanning may be continued by pressing either the blue
ARROW UP or ARROW DOWN buttons.
Once you have set up the BIG
BUTTON™ for your equipment, it works like your original remote controls. To
operate, just aim it at your equipment, press an appropriate Device Mode Button
and then command the desired function by pressing a corresponding button on the
BIG BUTTON™. The indicator turns on during signal transmission and as
confirmation of button touch. At your button touch, the BIG BUTTON™ illuminates
the keypad for 5 seconds. You will see the keypad clearly even when you are in
a dimly lit area.
Setup code list by next post.