Monday, December 03, 2012

SONY ERICSSON _ T630 _ T628 _ Disassemble Procedure _ 2 of 2





                                                   [2]
Contn:

  • Lift the display with your fingers. You may have to loose the latches at the arrows.  Do not touch the display glass with your fingers.

  • Remove the ZIF tape with the help of a pair of tweezers.  Open the ZIF-connector, connected to the display, with a pair of tweezers.  Be careful not to damage the ZIF-connector.






  • Remove the Flex film from the ZIF-connector with the flex film-assembly tool.  Use the correct pair of tweezers




  • Open the ZIF-connector, connected to the dome foil assembly, with a pair of tweezers.
  • Be careful not to damage the ZIF-connector.
  • Remove the Flex film from the ZIF-connector with the flex film assembly tool.
  • Use the correct pair of tweezers.

  • Remove the joystick button with your fingers.  The Joystick may be a little bit tight fitted to the switch.  If necessary use a pair of tweezers. Put the tweezers under the joystick button and press gently upwards.  Be careful not to damage the button, gasket and PCB when using a pair of tweezers.

  • Release the PCB from the frame cavity by overturn the frame.
  • Tilt the camera and remove it from the camera holder by sliding it gently with your fingers in the arrow  direction.  Be careful not to damage the camera holder or camera flexfilm when removing the camera.  Lift the camera board to board connector  gently with a pair of tweezers.  Be careful not to damage the components on the PCB when using the pair of tweezers

  • Remove the system connector from the board with your fingers.
  • Remove the speaker gasket.  Use a pair of tweezers.  Removed speaker gasket can not be reused and must be scrapped.  Do not touch the contact pads on the speaker with your fingers.
  • Pick up the speaker from the frame cavity with a pair of tweezers.  Do not touch the contact pads on the speaker with your fingers.
  • Pick up the microphone from the frame with a pair of tweezers.  
  • Gently push the camera key and the two volume keys in from the outside.  Be gentle.  Keys might be cosmetically damaged if pushing to hard.  Pick it up on the inside with a pair of tweezers.  The rubber can be damaged when picking it up.


  • Remove the internet access key by gently pushing it in from the outside.  Be gentle.  The rubber can be damaged when picking it up.  Pick it up on the inside with a pair of tweezers.


  • Remove the Sim lock lid with your fingers by first open it.  Lift it up and then pull it backwards.



at