HITACHI - LCD - 32LD9700C _32LD9700U _ 32LD9700N _ 37LD9700C _ 37LD9700N _ 37LD9700U _ ADJUSTMENT MODE _ MEMORY INITIALIZATION

TO ENTER ADJUSTMENT MODE

• Using the R-side control buttons with the set turned off (standby) can activate it.
• Press the [SUB-POWER] button, [INPUT SELECT] button and [DOWN] button at the same time and hold for more than 5 seconds.
• The set turns on in adjustment mode with OSD.

TO SELECT ITEMS & DATA VALUES.

• When the set is in adjustment mode, the cursor [LEFT | RIGHT | UP | DN] and OK buttons of the remote control or R-side control buttons may be used as the adjustment keys.
•  [UP | DN] buttons are used for selecting adjustment code.
• [LEFT | RIGHT] buttons are used for changing data values.
• [OK] button is used for confirming the data.
• After finishing the necessary adjustment press [MENU] button. Adjustment mode is released and the set returns to normal condition.

MEMORY INITIALIZATION

NOTE: The execution of this function returns the adjustment codes to the preset values, therefore, adjustment data will be lost.

• Enter Adjustment Mode.
• Select MEMORY INIT adjustment code (No.898) and change the data value from 0 to 1.
• Activate MEMORY INIT by pressing OK button.
• Select [No.712] and change data value from 1 to 0.
• Check that the receiving channel goes to P1. Unit is set to preset values.

TO CHECK THE USE ACCUMULATION TIME FOR PANEL

•  Select [No. 894] of Service Adjustment Menu.
• ( When No.894 is displayed as “65535” select [No.893] and change data value from 0 to 1. 
• Check No.894 is displayed as “0”.)