- Put machine flatly on operation table with well protection of machine appearance.
- Use electric screwdriver to take out 6 screws for fixing machine rear cover.
- Disassemble machine rear cover without too much force to prevent from damaging machine cover.
- Tidy flat cable of boost board and take out flat cable from clasp before disassemble.
- Take out flat cable of boost board
- Put machine flatly on operation table as the picture shows Remark.:LT1000Smachine has no loader components. LD1006SI &LD1006Ti machines have loader components.
- Take out soft cable from driving board to video main board ( remove red glue before taking out flat cable).
- Plane chart of display screen component
- Disassemble screw of driving board.
- Take out soft flat cable of display screen component without breaking.
- Disassemble display screen and other subsidiary board after remove flat cable.
- 5 screws of fixing loader needs to be removed if machine has DVD function. Be aware that there are two screws inside loader to fix.
- Take out loader component (clasp should be pulled out to take out loader)
- When replacing loader, cabling of new loader flat cable should in accordance with cabling way of taking out old loader.
- Take out tuner antenna extending wire of video main board.
- Take out main board screw and take out video main board.
- Bottom chart of video main board , pay attention to anti-static when taking out video main board.
FLOWCHART OF PLAYER ASSEMBLY
- Install button board/battery socket/antenna extending wire to bottom casing without scrap bottom casing.
- Fix video main board onto bottom casing, and install antenna.
- Insert panel flat cable and battery socket flat cable, bottom component is installed.
- Insert flat cable from driving board to display screen without deflection
- Use screw to fix driving board, and insert soft flat cable into extension socket (J1003) of driving board.
- Install boost board and remote control subsidiary board in order. Stick PVC piece to flat cable from driving board to remote control subsidiary board. Prevent conductive shield cloth covered outside flat cable and video main board short-circuit.
- Insert soft flat cable on driving board to video main board J104 without deflection to prevent from damaging flat cable.
- Insert boost board power supply flat cable, and block flat cable to slot of panel to prevent from cable trouble machine devices.
- Close outside cover of machine, install to the just position, otherwise screws can't be fixed.
- Fix 6 screws of machine rear cover and machine assembly is finished.
