REF610A - Infinity Car Audio - Troubleshooting and Wiring diagram
WIRING DIAGRAM
CLICK ON DIAGRAM TO ZOOM
TROUBLESHOOTING
PROBLEM:
No audio (POWER LED is off).
CAUSE and SOLUTION:
No voltage at BATT+ and/or REM terminals, or bad or no
ground connection. Check voltages at amplifier terminals with VOM.
PROBLEM:
No audio (PROTECT LED flashes every 4 seconds).
CAUSE and SOLUTION:
DC voltage on amplifier output. Amplifier may need service;
see enclosed warranty card for service information.
PROBLEM:
No audio (PROTECT LED is on).
CAUSE and SOLUTION:
Amplifier is overheated. Make sure amplifier cooling is not
blocked at mounting location; verify that speaker-system impedance is within
specified limits.
PROBLEM:
No audio (PROTECT and POWER LEDs flash).
CAUSE and SOLUTION:
Voltage less than 9V on BATT+ connection. Check vehicle
charging system.
PROBLEM:
No audio (PROTECT LED is on).
CAUSE and SOLUTION:
Voltage greater than 16V or less than 8.5V on BATT+
connection. Check vehicle-charging system.
PROBLEM:
Distorted audio.
CAUSE and SOLUTION:
Input sensitivity is not set properly, or amplifier or
source unit is defective. Check INPUT LEVEL setting, or check speaker wires for
shorts or
grounds.
PROBLEM:
Distorted audio (PROTECT LED flashes).
CAUSE and SOLUTION:
Short circuit in speaker or wire. Remove speaker leads one
at a time to locate shorted speaker or wire, then repair.
PROBLEM:
Music lacks “punch.”
CAUSE and SOLUTION:
Speakers are not
connected properly. Check speaker connections for proper polarity.