Tuesday, August 13, 2013

MARANTZ CD6002 DVD PLAYER - HOW TO UPGRADE FIRMWARE [Software Upgrade Procedure]



SOFTWARE UPDATE
Necessary equipment
Windows PC (OS: Windows2000 or WindowsXP) with Serial port.
RS-232C Dsub-9 pin cable (female to female/straight type).
Connection JIG (90M-SR4500JIG)
Update tool (FlashProg.exe, other files and folders in Flash Programmer folder)
Update data (CD6002_yymmdd_x.s24)
NOTE :The yy is two digits of year. The mm is month. The dd is date. The x is release number.
  • Put the "Flash Programmer" and "software" folder into anywhere on your PC’s hard disc.
  • Double click the "Flash Programmer" folder.
  • Double click FlashProg.exe, and launch the Flash Programmer.  When a Flash Programmer does not launch even if double-clicked FlashProg.exe, please refer to "[B] When a Flash Programmer did not launch".
  • Click OK.
Since Flash Programmer communicates with the unit automatically, the following dialog box appears when it fails in communication.
  • Click the Setup in the menu bar and select the Object file.
  • Click Browse
  • Choose the Motorola S Format(*.s16,*.s24,*.s32)in Files of type.
  • Choose the CD6002_yymmdd_x.s24, and click Open.
  • Click Device tab.
NOTE: The yy is two digits of year. The mm is month. The dd is date. The x is release number.
  • Choose the TMP91FW60in the Device, and choose the 900/L1in the Series.
  • And click Communication tab.
  • Choose  the Serial port number in the COM Port.
  • Check the Data Rate Manual, and choose the 38400 in the Data Rate.
  • And Click OK
  • Disconnect the mains cord from the unit.
  • Connect the RS-232C on the connection JIG and the Serial Port of windows PC with RS-232C cable.
  • Connect FFC (upside contact) to the rear panel of the unit from connection JIG.
  • Connect the mains cord into the unit.
  • If the connection with the Flash Programmer is successfully made, a dialogue box saying "Erase All data in this devise? (Y/N)" appears automatically. If the connection fails, error message will appear. (Ex.: E000)
  • Click Yes.
  • Click OK.
  • Click P (Program) to start update.
  • Software is written into the microprocessor.
  • The writing of software takes about 50 seconds.
  • If the software is updated successfully, a dialog box saying "R006: Programming completed successfully." appears.
  • Click OK.
  • Click  the File in the menu bar and select the Exit.
  • Disconnect mains cord from the unit, and then disconnect FFC of connection JIG from the unit.

When a Flash Programmer did not launch
  • Open the FlashProg.ini in the Flash Programmer folder by text editor. (EX.: Notepad, etc)
  • Delete the text "OpenFile=C:\...(your PC setting)...\???.s24"
  • Save the FlashProg.ini.
  • Close the text editor.
  • Probably you can launch the Flash Programmer.

at