SANYO - PROJECTORS - SERVICE MODE ENTRY

                                The procedures will be different to model to model.

                                              TO ENTER SERVICE MODE

1. Simultaneously Press and Hold, "Menu" & "Input" buttons on the Projector for more than [5] seconds. [OR] 
2. Press and Hold "Menu" button for about [20] seconds.
3. The "S" will be displayed on the screen indicating that the Projector is ready to accept more commands to get into Service Mode Status.
4. While "S" is being displayed, Press and Hold [Up & Dn] buttons on the projector [OR] 
5. Screen Button on the Remote Control, for more than [3] seconds.
6. The Service Menu will be displayed.

                BUTTONS AND ACTIONS

• OK  =>  A group number increases.
• Menu  =>  A group number decreases.
• Up  =>  An item number increases.
• Down  =>  An item number decreases.
• Right  =>  An adjustment value increases.
• Left  =>  An adjustment value decreases.

     Press the Power ON/OFF button only once on the Projector or Remote control, to 'Exit" service mode.

                             AN OTHER WAY TO ENTER SERVICE MODE STATUS

1. Press and Hold "Select" & "Input" buttons on the Projector simultaneously for about 10 seconds.
2. The "Factory menu" will be displayed.
3. Use [Up or Down] / [Left or Right] buttons to move through Menu items, and change the data values.
4. To 'Exit" service mode, switch Off the Projector. 

                                                           OR

• Press and Hold the "Menu" on the projector for about 10 seconds.
• The Service Menu will be displayed.
• Use [Up / Dn] buttons to call an item to adjust.
• Use [Left / Right] buttons to adjust the data value to selected item.
• Turn OFF the Projector, to "Exit" Service Mode.