INITIALIZATION
This initializes the data for the
function, volume, DVD mechanism (RL-874), etc.
- Check that the AC cord is disconnected from the power outlet. (AC OFF)
- While pressing the FUNCTION and OPEN/CLOSE buttons on the main unit, plug the AC cord into the power outlet. (AC ON)
- Check that the entire display and all the LEDs light,then release the FUNCTION and OPEN/CLOSE buttons.
- After about 3 seconds, "INITIALIZE" appears on the display.
- After initialization is complete (when "INITIALIZE" turns off), the function is set to "DVD" and the volume level is set to - ∞ ("-dB" is displayed).
SYSTEM CHECK MODE
Use this to display the version
information, etc.
- In the standby mode, while pressing the STOP and A.FWD [ >> ] buttons on the main unit, press the ON/STANDBY button.
- Press the STATUS button on the remote control unit (RC-1007) to display the following information, in this order: Time (TIME) → System microprocessor version (SYS Ver) → Date of system microprocessor version updating (SYS Date) → DSP version (DSP Ver) → Date of DSP version updating (DSP Date)→ Date of drive microprocessor version updating (Dr Date) → ESS version (Ess Ver) → Date of ESS version updating (Ess Date) → Region number (Region No.)
- To cancel, unplug the AC cord. (AC OFF).
- NOTE 1: The DVD mechanism driver version and ESS version are not displayed unless the function is once set to DVD.
