PIONEER PLASMA TV
Pioneer plasma sets uses a four digit code to control the V-Chip.
To reset Pioneer:
Put the receiver in standby mode, and hold down the 'Clear' button and 'Standby / ON' button on the plasma display. The device should now reset. If you want, you can run an auto install to configure your device.
Turn ON the Power, press 'Menu', select 'Setup' on the screen and press 'Enter'. It it asks for code, you have to reset the device again and start over. Otherwise, scroll to 'Auto Installation' and press 'Enter'.
PS2:
When you try to use a DVD that is blocked, it will ask for code. Press "Select" on the controller. Enter the detection code [7444] when prompted. You can then set a new lock code. Remove the the disc, and then turn OFF your PS2.
QWESTAR
SIMPLY ENTER CODE [3308].
