This remote control have setup codes for almost all TVs and DVD sets.
SETUP PROCEEDINGS
Fetchtv features a universal remote that can be programmed to also control your TV & DVD.
- To program your remote follow these steps:
- Check the list of TV and DVD brands below to identify the codes for your TV or DVD.
- If there is more than one code listed you will need to try each of them to determine which one is best for your equipment.
- Choose the mode by pressing either TV or DVD on your fetchtv remote (you can’t reprogram it for the STB).
- The button should light up and then go off when you choose the mode.
- Hold down the? RC Setup button until the selected mode button (TV or DVD) flashes once and then, after a pause, twice more.
- Type in the first of the 4 digit codes shown on the list for your brand of TV or DVD. The selected mode button will flash each time you enter a number.
- If the 4 digit code has been successfully entered, the mode button will flash twice after you enter the last number.
- If you type in an incorrect code the mode button will light up solid red and will not flash twice. You will need to start again from the beginning.
- Once you have correctly entered the code you then need to test whether it is the correct one for your model of TV or DVD. To do this check that the correct mode (TV or DVD) is selected on your fetchtv remote & then press the on/off button to see whether it turns on your TV or DVD.
- If ths does not work, it means the code you programmed is not correct for your TV or DVD. You need to repeat these steps using the next code shown on the list for you brand of TV or DVD.
- If it does work, test other buttons to check you are able to access the full functionality. It is possible that there are several codes on the list for your brand of TV or DVD that will work better than others. You may need to try several to find the best one.
- When you have found a code that works well, take off the battery cover of your fetchtv remote control. Write the code on the sticker inside the cover. You will need to re-enter the code if the batteries are removed from the remote control.
