Dell E1909_19" lCD Monitor_Disassemble Procedure. [Horizontal Frequency: 30 kHz to 83 kHz]
Click on the pictures to Zoom In
* Put the monitor on the soft plane table, to avoid scrapping the
panel.
* Remove the cable cover as the arrow shown.
* To remove stand press the button at the same time
pull out the hinge cover follow the arrowhead direction and remove it, then
remove the hinge.
* Remove the four screws and remove the base.
* Pry the monitor up then find out the hooks’ position, use the
tool (like the picture or other card) to insert into the gap of bezel and rear cover,
then turn over the monitor and take off the rear cover.
* Remove the key board: Remove the screws marked in red.
* Disconnect connector remarked in green.
* To remove shield: Remove the four screws and remove the main
frame by manual or torque = 3kgF.Cm and disconnect connector marked in green.
*To remove the power board: Remove the screws remarked in red.
