Display Assembly_ Top Cover_ keyboard & ODD Drive Removal
- L360 – L365 – TOSHIBA NOTEBOOK
Disassembling the ODD bezel.
Disassemble the ODD drive according to the following
procedures.
Push out on the ODD bay module in the direction of the
arrow.
Disassembling the ODD Drive.
Do not disassemble the ODD drive when it is working
normally. Disassemble or replace the ODD drive only if it fails.
* Remove two M2x3 black flat head screws.
* Remove the bracket.
Removing Keyboard
Remove the Keyboard according to the following procedures.
* Release the following 11 latches on the keyboard cover, in
that order:
* One latch on right side and one latch on left sides.
* Four bottom latches.
* Five front latches.
* Remove the keyboard cover.
* Remove four M2.5x2.5 black flat head screws.
* Disconnect the keyboard cable from CN250 on the system
board.
* Remove the keyboard.
Removing the Wireless LAN Card
CAUTION: Do not touch the connectors on the wireless LAN
card and in the computer with your bare hands. Wireless LAN cards can fail if
they are contaminated with sweat, natural oils, etc. from your hands.
* Disconnect the two antenna cables with tweezers.
* Remove one M2x2 black flat head screws securing the wireless
LAN card.
* Pull the wireless LAN card up from CN1300 on the system
board and out at an angle.
Removing the Top Cover
* Turn the computer upside down and remove the following 18
screws:
* Twelve M2.5x6 black flat head screws.
* Four M2x2 black flat head screws.
* Turn the computer right side up.
* Disconnect the touch pad board flat cable from CN280.
* Disconnect the power board flat cable from CN201.
* Disconnect the speaker cable from CN600.
* Lift up the top cover.
Removing the Display Assembly
* Open the display panel.
* Disconnect the LCD/FL cable from CN3000 on the system board.
* Remove four M2.5x5 black flat head screws securing the LCD
module to the bottom cover.
* Remove the wireless antenna cables from the bottom cover.
* Remove the display module.
