ATLAS PATIENT MONITOR - POWER SUPPLY BOARD - FUSE LOCATION'S AND MORE [MEDICAL EQUIPMENT]

POWER SUPPLY REMOVAL

• Slide the power supply out from the E-Pac Foam.
• Power Supply Fuse Location

NOTE: Notice power supply and power supply fuse location.

• Fan Removal

Slide fan out from E-Pac foam.

• E-Pac Removal (Lower)

Remove lower E-Pac foam from unit.

• Deflection PCB Removal

Carefully remove the small deflection PCB from the CRT.

• CRT Removal

Remove the two machine screws holding CRT to the front panel.

NOTE: Notice how the ground wire is attached and is located along the side of CRT.

NOTE: The CRT and deflection PCB are factory tuned as a unit and are sold only together as a unit.

• Display PCB Removal

Remove all 9 self-tapping screws that hold the Display PCB to the Bezel.

NOTE: Notice the correct orientation of CRT screw and washer.

• Printer Door Button Removal

Use a small screwdriver to push the door button tab up and away from the pin that locks it onto the printer frame.

NOTE: Notice how the printer button is being removed.

• Printer Assembly Locking Tab Release.

Pull the locking tab down and towards the front of the rear housing assembly.

• Printer Positioning Slot Removal

Make sure printer door is open. Begin to pull the positioning slots towards the front of the rear housing and then out from the rear housing.

• Printer Assembly Removal.

After printer positioning slots have cleared the front rear housing, pull the printer down and out of the rear housing.

• Printer Lip Assembly.

Observe how the printer assembly fits into the lip of the rear housing.

• Printer Cable Routing.

Observe how the printer cable lies over the printer PCB.