Move the CR Unit to the center, open the Cartridge Cover and
remove all Ink Cartridges.
While disengaging the hook of the Head FFC Cover with a
flat-head screwdriver, slide the Head FFC Cover downward and remove it.
While disengaging the hook of the Head FFC Cover Inner with
a flathead screwdriver, slide the Head FFC Cover Inner upward and remove it.
Using the special tool disengage the hook A of the Holder
Contact on the left back of the Carriage Unit.
Using the special tool disengage the hook B of the Holder
Contact on the right back of the Carriage Unit.
Slide the Holder Contact upward and remove the Holder
Contact.
Take extra care not to spill ink and contaminate the
surroundings.
Be extremely careful not to touch the nozzle surface, the
ink supply needles and the Head Cover, otherwise the nozzles may get clogged.
Remove the three screws and remove the Printhead.
Screw : C.B.P. M2.6x8 (tightening torque: 3-5 kgf.cm)
(The numbers shown in the figure indicate the order of
tightening the screws.)
Remove the two Head FFCs from the connectors on
the back, and remove the Printhead.
{Special Tool}
