Remove the three black screws in rear low cover.
Remove the six black screws.
[1] Remove the four silver screws (1) remove the panel stand from the panel holder as in the arrowed direction.
[2] Remove the four silver flat screws (2).
[3] Remove the two black screws (3).
[4] Remove the two silver screws (4).
[5] Remove the panel holder from PDP.
[6] Disconnect CN901 & CN903 from PDC board.
[7] Remove the four silver screws (5) and remove the PDC board.
[1] Remove the 8
silver flat screws around the two panel holder (1).
[2] Remove all aluminum
foil around panel (2), after assemble the new panel, must re-fix the aluminum
foil , if it is broken, change a new one, otherwise the EMI can be affected.
[3] Remove the four
silver screw around the panel corner (3).
940 Tow people must hold the panel holder 1 and 2 respectively, and then uplift the panel module and move it out from the front cover [Bezel].
PANEL [INTERNAL VIEW]
PANEL DEFECTS
A panel may have defective cells that cannot be controlled.
These defective cells can be categorized into three types;
- Non-lighting cell defect: defect in which the cell is always off
- Non-extinguishing cell defect: defect in which the cell is always on.
- Flickering cell defect: defect in which the cell is flickering.
Test Pattern: Full White, Full Red, Full Green and Full Blue
with 1023 (10 Bit) gray level.
The display effect
specifications define the allowed limits for display cell defects are used as the criteria in determining
whether a panel should be allowed.
Item
|
Number of cell defects
|
Distance between cell defects
|
Non-lighting cell defect
|
Zone A: 3 and less
Zone B: 8 and less
|
|
Non-extinguishing cell defect
|
Zone A: 0
Zone B: 1 and less
|
Regardless of A and B zone, Distance between the cells is
over 15mm
|
Total Defect
|
Total number of cell
defects in Zone A and B is 8 and less
|
|
Flickering cell defect
|
Zone A: 0
Zone B: 1 and less
|
DEFINITION OF PIXEL DEFECTS
Defects of Glass Filter
But, the distance between defects must be over 30mm.
Both parties shall
settle any defect without prescribed contents on the specifications on deliberation.
