This is a common fault to occur in most of the CRT based televisions, regardless of which brand it is. There will be sound OK, and a bright screen with thin white horizontal lines across; at about an inch space in between, all over the screen area. This fault may occur along with color shades also, like blue screen with white retrace line, red screen with white retrace lines, green screen with white retrace lines.
Let us take the first case.
A white raster with white thin retrace lines across the entire screen area. These are called vertical retrace lines technically. To make it more understand, we have to go to some picture tube electrode details.
There are three color cathodes for a color picture tube, Red, Blue and Green. Two girds are there called Focus and Screen.
Focus grid is supplied with focus voltage which in turn determine the focus of picture, and screen grid is supplied with screen voltage, will be much lower than the focus voltage, which determine the emission of the picture tube. There is a final anode supplied with Extra High Tension voltage, can be located at the top side of the picture tube, to which the EHT [Extra High Tension] voltage from LOT [Line Output Transformer] is connected with the help of rubber cap and clip. Without these three voltages, EHT, Screen and Focus, no raster will be produced. Therefore in our case, there is a raster, so, horizontal output section including Line Output Transformer [LOT] is functioning well, and as far as sound is there, tuner and video IF sections are working well. In fact, all other section except, video output section is working properly.
There are three cathode points on the base card, marked as Bk, (blue Cathode) Rk(Red Cathode) and Gk(Green Cathode). Check the voltages of these three cathodes. In our case, it will be very low or approximately equal to zero. When cathode voltages goes low, emission of the CRT increases, is the reason. There must be a voltage between 120 and 135VDC at these points. Find out the reason for this voltage drop is the next step.
There are three cathode points on the base card, marked as Bk, (blue Cathode) Rk(Red Cathode) and Gk(Green Cathode). Check the voltages of these three cathodes. In our case, it will be very low or approximately equal to zero. When cathode voltages goes low, emission of the CRT increases, is the reason. There must be a voltage between 120 and 135VDC at these points. Find out the reason for this voltage drop is the next step.
The video drive voltages in most TVs come from LOT windings, after rectification and filtering. There will be one resistor of low value, say one Ohms or so, will be connected series with this winding, in between rectifier diode and winding. Check the voltage at the cathode of this rectifier diode first. If found low replace the diode and the smoothing capacitor. The smoothing capacitor will be between 33 and 47MFD 350VDC rating. Replace both of them. If there is voltage, say 200VDC or so, check whether this voltage comes to the CRT base board or not, If not, check the conducting wire, serial resistors; if used for open. There is no chance of transistor shortage at this time as the raster we see is white. If raster we see have a specific color predominant, that is green, blue or red, check the reverent video out transistors and replace it. It is best to replace all the three video output transistors at the same time with same batch and number
Check the soldering terminals of video output transistors’ load resistors (usually have values from 12Koms to 15Kohms. These resistors will heat up while working. Repeated heating and cooling may make the solder terminals of these resistors to be loose, as a result, supply to the collector point of respective transistor will go low. In short, first look for any loose soldering points on the picture tube base card [Video Output Card]. In most cases, fault will be there.