ENTERING INTO SERVICE MODE AND MAKING ADJUSTMENTS.
Part-1
To enter into the service mode, you can use the remote control handset supplied with this set [RM-887]. Before making any adjustments, not all the preset adjustments first. Then make a change any value. This will help you to reset the values to its original, if you accidentally go out of range of these values
To enter into the service mode
[1] Turn ON the main power switch and enter into the stand-by mode.
[2] Press the following sequence of buttons on the Remote Commander.
ON SCREEN DISPLAY > DIGIT 5 > VOLUME + > TV
‘TT—‘ will appear in the right upper corner of the screen. Other status information will also be displayed.
[3] Press Menu on the remote commander to obtain the following menu on the screen.
TEST MENU
|
> Picture adjustment
|
Geometry
|
Wide
|
IC Status
|
MSP
|
Dynamic Convergence
|
Current TV status
|
[5] Press the (+) button to enter the selected adjustment.
[6] Turn OFF the power to quit the service mode, when adjustments have been completed.
All preset values to the above stated parameter comes with next blog.
Continued on part-2
