TO ENTER SERVICE MODE
Using customer remote control
- [Power Off => Mute => 1 => 8 => 2 => Power On]. (Interval between key strokes: less than 3 seconds)
- To "Exit" service mode, Power Off the set, and switch it back On again.
Using Factory Remote control.
- [Power On => Info => Factory key]. Interval between strokes: less than 3 seconds.
- Press the "Factory" key twice, with a key stroke interval of more than one second {pressing once enters Aging Mode}
Settings when entering Factory Mode
- Sharp Screen (Dynamic), Color tone (Cool-1), Factory (Dynamic CE Off)
Adjustment Procedures
- To select an item, use [Up or Dn] keys, on the remote control.
- To adjust the data value to selected item, use [Left or Right] keys on the remote control.
- Press 'Menu' key to save the settings to the EEPROM and to return the higher-level mode.
- To select channels, use (0 to 9) keys.
- To switch AV modes, use the 'Source' key.
Initial Service mode Display
--------------------------------------------------------------------------------------------------------------
- Calibration xxxxx xxxxx
- Option table xxxxx xxxxx
- White Balance
- SVP-FX
- Option Block
- STV8258 / STA323W
- YC Delay
- Adjust
- -------
- W/B Movie
- Checksum
- Reset
T-SPRN42NUS-XXXX
T-SPRMNUS-S-XXXX Boot Merge: OK.
Month / Day / Year
Hour / Minute / second
----------------------------------------------------------------------------------------------------------------
# The version of the firmware displayed at the bottom of the screen may differ and the firmware is subject to change for the improvement of product functions.
# If you have adjusted the settings in Service Mode, have to reset the product.
No comments:
Post a Comment