Caution: it is mandatory to remount all different screws at
their original position during re-assembly. Failure to do so may result in
damaging the SSB.
- Release the clips from both the LVDS Flat Foil connectors that connect with the SSB [1]. Caution: be careful, as these are very fragile connectors. Take the flat foils out of their connectors.
- Release the clamps and unplug all other connectors [2].
- Release the tape [3] near the bottom side of the set from the LCD panel.
- Remove the fixation screw from the clamp near the bottom of the SSB, and take the clamp out [4].
- Remove all other fixation screws from the SSB [5].
- Take out the SSB together with its shielding.
- Remove the screw near the L/R audio connectors [6].
- The SSB can now be shifted from the side connector cover, then lifted and taken out of the shielding [6].
POWER SUPPLY UNIT
- Release the Power board cables from their clamps.
- Unplug power connectors from the SSB, as it is not unplug-able at the PSU itself (soldered connector).
- Unplug all other connectors from the PSU.
- Remove all fixation screws from the PSU.
- The PSU can be taken out of the set now.
STAND BRACKET REMOVAL
- Remove the fixation screws [1], [2].
- Take the Stand bracket out.
IR/LED/KEYBOARD REMOVAL
Caution: The touch control function needs to be checked when
it is replaced.
- Use test finger with a 8 mm. diameter to touch center of key icon on front cover.
- Press touch key sensitivity test hot key “0 6 2 5 9 0 MENU”, check the sensitivity count value of each key (CH +/-, HOME, VOL +/-), when touching key icon on front cover.
- The value count of each key should be over 100.
LCD PANEL
- Remove the SSB as described earlier.
- Remove the PSU as described earlier.
- Remove the stand bracket as described earlier.
- Remove the speakers as described earlier.
- Release the tapes from the cables of the IR/LED/KEY board.
- Release the clips from both the LVDS flat foil connectors [1].
- Caution: be careful, as these are very fragile cables and connectors. Take the flat foils out of their connectors.
- Remove the fixation screws [2] at the bottom left of the panel that secure the LCD panel with the bezel. Remove metal clip from its position. Be careful not to break the clicks that secure the metal brackets.
- Remove the other fixation screws [3] and [4].
- Lift the LCD Panel from the bezel.
- When defective, replace the whole unit.
