TO ENTER SERVICE MODE [Remote control: RM-C13G TV]
Ensure that the cursor of the Use Menu screen pointing at picture control. Before entering the service mode, confirm that the settings of TV | CATV switch of the remote control unit is at the "TV' side, and the setting of VCR | DVD switch is at 'VCR" side. If the switches have not been properly set, it is impossible to enter into service mode.
- Set to [0] minutes using 'Sleep Timer" key.
- Press the 'Video Status" & "Display" keys simultaneously, to enter the Service Mode.
- When the 'Man Menu' is displayed, press any key of (0) to (9) key to enter corresponding menu mode. * Press any of the (0) to (9) keys before the service mode disappears.
- Use [Ch Up] / [Ch Dn] keys to call an item to adjust.
- Use [Vol Up] / [Vol Dn] keys to adjust the data value of selected item.
- Press "Muting" key to Save the value.
- Press [Back] key to [Exit] the service mode.
DESCRIPTION OF STATUS DISPLAY
_________________________________________________________________________________
NTSC CINE ST L FL MUTE
_________________________________________________________________________________
NTSC => SIGNAL SYSTEM
CINE => ASPECT | MULTI
ST => VIDEO STATUS
L => WHITE BALANCE
FL => IP CHANGING MODE
MUTE => MEMORY
ADJUSTMENT PREPARATION
- Make the necessary adjustment for the unit with either the remote control or with the adjustment tools.
- Adjustment with the remote control is made on the basis of initial setting values, however the new setting values which set the screen to its optimum condition may differ from the initial settings.
- Make sure that AC power is turned On correctly.
- Turn On the power for set and test equipment before use, and start the adjustment procedures after waiting at least 30 minute.
- Unless otherwise specified, prepare the most suitable reception or input signal for adjustment.
- Never touch any adjustment setting value which are not specified.
SERVICE MODE ITEMS
- Picture | sound => This sets the setting values of the Video | Audio and Deflection circuits.
- YC SEP => This is used when YC seperation circuit is adjusted.
- White Balance => This sets the setting values of White Balance (do not adjust).
- Memory Setup => This sets the values of memory address (do not adjust).
- RF AGC => This is used when the IF VCO is adjusted. (D not adjust).
- DD | CM => This sets the setting values of the panel image processing.
- Panel => This sets the values of the panel power limit control.
- PP => This sets the setting value of the output of Multi Piclture circuit.
- IP => This sets the setting value of the DIST circuit. (Do not adjust).
- HDMI => This set the setting value of Digital input Module Circuit. (Do not adjust).
