Monday, August 06, 2012

MITSUBISHI - XL 30 XL 25 SL 25 LAMP REPLACEMENT AND LAMP RESET PROCEDURE


  1. Reverse the projector gently.
  2. Loosen the screws of the Lamp Lid, and remove the Lid.
  3. Loosen the lam fixing screws, and remove them.
  4. Pull up the handle.
  5. Hold onto projector by the handle as you pull out the lamp.
  6. Once the lamp has been removed, do not spill liquid on it
  7. Insert the new lamp securely into the projector body in the right direction.
  8. Put the handle back to the holding point.  Make sure that the handle is locked.
  9. Tighten the screws.
  10. Tighten the screws of lamp lid
LAMP TIME RESET
  • Plug in the power cord, switch On the projector, and reset the lamp time by pressing [ <, >] and the Power button on the control panel simultaneously.  
  • If the three buttons are not pressed at the same time, lamp time may not be reset.
  • The projector will not turn ON if lamp lid is not secured 
  • Confirm that the temperature indicator illuminates about 2 seconds and the lamp time has been rest.
  • Must reset the the operation time meter after the replacement of lamp.
  • Do not reset the operation time meter unless the lamp has been replaced.