OPERATION OF RS232 WRITING
- RS-232 mounted one the main board is the main interface writing new firmware. Can update new firmware to U40 by RS-232.
- Writing firmware needs;
- RS-232 interface built in PC.
- RS232 cable.
- Pixelworks Flash Upgrade software.
- Connect RS232 interfaces between PC and TV set.
FIRMWARE WRITING PROCEDURE
- Execute Pixelworks Flash Upgrader software.
- Select Baud rate by 115200.
- Download "appcode.crams" file.
- Choose "Flash" Mode entering standby status for writing firmware.
- Turn ON the TV set.
- "Bytes Bar" will appear on the screen in few seconds indicating firmware is downloding.
- The download process will take about4 minutes. It won't change the original code when download process intercepted. Once download process finished, system have to take at least 30 seconds updating new firmware. Make sure power is supplied without interruption; otherwise the system will shut down.
- System will restart automatically after finishing writing process.
FUNCTION TEST
Check item
|
Describe
|
POWER
|
PRESS [POWER] TO TURN ON OF OFF LCD TV.
|
REMOTE CONTROL EFFECTIVE RANGE
|
THE EFFECTVIE RANGE IS 5 MENTER FROM LCD SENSOR.
|
INDICATOR LED
|
TURN ON: GREEN
LIGHT.
TURN OFF: RED LIGHT DPMS STATE FOR PC/HDMI MODE : RED
LIGHT.
|
EARPHONE
|
PLUG IN THE EARPHONE, CHECK THE SPEAKERS IS MUTE.
PLUG IN THE EARPHONE, CHECK THE EARPHONE WORKING.
PLUG IN THE EARPHONE.
ADJUST THE VOLUME AND MAKE SURE THE VOLUME OF EARPHONE FOLLOW THE
ADJUSTING.
|
MENU
|
PRESS ‘MENU’ KEY TO MAKE SURE THE OSD PICTURE WILL SHOW
OUT.
|
CHANNEL
|
PRESS ‘CHANNEL’ UP/DN TO CHECK THE CHANNEL NUMBER CHANGE
NORMALLY.
PRESS ‘RECALL’ TO CHECK SWITCHING PREVIOUSLY VIEWED
CHANNEL NORMALLY.
PRESS NUMBER KEY AND [-/100] TO ENTER THE CHANNEL NUMBER.
|
VOLUME
|
PRESS ‘+’ / ‘-‘ TO CHECK THE VOLUME INCREASES OR
DECREASES.
|
SOURCE
|
PRESS ‘SOURCE’ KEY AND CHECK EACH SIGNAL SOURCE IS
NORMALLY. PRESS HDMI | PC } S-VIDEO |
AV | COMPONENT | TO ENTER HDMI, PC, S-VIDEO, AV, COMPONENT MODE.
|
SCREEN
|
PRESS ‘WIDE’ WILL SWITCHES IN SEVERAL SCREEN MODE : AUTO, 4:3, 16:9, 14:9.
PRESS ‘DISPLAY’ WILL SHOW THE INPUT SIGNAL SOURCE.
|
AUDIO
|
PRESS ‘MUTE’ TO DISABLE AUDIO.
PRESS ‘MTS/SAP’ TO SWITCH SAP, MONO, STEREO MODE.
|
