HITACHI Projection TVs _ WD7000 - FD7000 - FL7000 - Convergence for outside digital & Convergence data adjustment procedure
Convergence for Outside Signal function
1. Press Service Switch on POWER/DEF P.W.B then display "Normal
Crosshatch"
2. Press [MENU] key on R/C, then display "Red + Green Crosshatch
with Red Marker" or "Green Crosshatch with Green Marker" or
"Blue + Green Crosshatch with Blue Marker"
3. Press [MENU] key on R/C again, then display "Normal
Crosshatch on Main Picture"
4. Press [MENU] key on R/C again, then display "Cross Marker +
Box Marker on Main Picture"
5. Press [MENU] key on R/C again, then display "only Box Marker
on Main Picture"
6. Press [MENU] key on R/C again, then display "Normal
Crosshatch" again.
[And repeat procedure 2) ~ 6) by each press [MENU] key on R/C]
Convergence Data Adjustment Method
This function can adjust convergence data of all of one line (or
all of screen) at the same time, in CONVERGENCE ADJUSTMENT MODE.
> Press Service Switch on DEF/CONVER P.W.B. to set to CONVERGENCE
ADJUSTMENT MODE, then display Normal Crosshatch with Adjustment Point Marker.
> Press [SUB] key on R/C, then Extra horizontal lines appeared as
set to RATER POSITION ADJUSTMENT MODE.
If Adjustment Point is on center, by press cursor key on R/C, then
Convergence Data of all of screen are exchanged at the same time. By press [UP] [LEFT] key on R/C, move up
(left) RED convergence data of all of screen.
If Adjustment Point is NOT on center, by press cursor key on R/C,
then Convergence Data of all of one line that Adjustment Point Marker is
existing are exchanged at the same time.
By press [UP] [LEFT] key on R/C, move up (left) RED convergence
data of all of horizontal (vertical) line that Adjustment Point Marker is
existing.
Press [SUB] key on R/C again to exit RATER POSITION ADJUSTMENT MODE
