Samsung LCD Monitor P2770HD – How to upgrade the software

Firmware upgrade procedure – Samsung P2770HD – LCD monitor

USB Download Method
1. Insert a USB drive containing the frmware upgrade into the USB port on the rear of the TV.
2. Press the MENU button to display the menu.  Press the or button to select “Support”, then press the ENTER button.
3. Press the or button to select “SW Upgrade”, then press the ENTER button.  The message “Scanning for USB. It may take up to 30 seconds.” is displayed.
4. The message “Upgrade version XXXX to version XXXX?  The system will be reset after upgrade.” is displayed.  Press the or to select the “OK”, then press the ENTER button.

Be careful to not disconnect the power or remove the USB drive while upgrades are being applied. The TV will turn off and turn on automatically after completing the firmware upgrade. Check the firmware version after the upgrades are complete. When software is upgraded, video and audio settings you have made will return to their default (factory) settings.  It is recommended you write down your settings so that you can easily reset them after the upgrade. upgrades for TV’s firmware in the future. Upgrades will be possible by connecting a USB drive to the USB port located on your TV.

Software Upgrade
Program Upgrading - MAIN
1. If you select MENU > Support > Software Upgrade on remote control, you’ll see below pictures.
2. Press ENTER, then you’ll see another display picture. Select Yes.
3. Micom program is now upgrading as in picture.  After Software Upgrade is process by 100%, the monitor is automatically turn off and on.

How to upgrade the micom program – Samsung

1. Prepare PC to Upgrade the Program.
2. Prepare the DDC Manager
3. Connect D-sub cable to Target Monitor TV
4. Power on the Target Monitor TV
- winDDC_V2-39 Program installed
- Run winDDC 

Click on the pictures to magnify

PC for MCU upgrading Connect to Parallel port.

1. Goto installed Program folder (winDDC_V2-39)

2. Run winDDC

3. Select WinISP Menu
4. Make same setting like picture.
5. Choose Flash memory type - ECOFIT-MFM(P2470HD):WT61P8

6. Load File ( Select fle to download)
7. Set Option to load Binary Files
8. Select fles (bin fle)
9. Click button to load fles

10. Select “Flash1” and “Flash2”

11. Check the OK message (Load)

12. Click Auto Program button

13. If you see OK message (Verify), program download is completed.

After Upgrading Firmware - Factory mode.

1. Factory remote control (SET POWER ON )  INFO > Factory.

2) Normal Remote control (SET POWER OFF) INFO > MENU > MUTE > POWER

After Reset , Set Power off.

Sub Micom Upgrade
1. Select WinISP Menu
2. Make same setting like picture.
3. Choose Device Type.  - ECOFIT-MFM(P2470HD):WT61P8.

4. Load File ( Select fle to download)
5. Set Option to load Binary Files
6. Select fles (hex fle)
7. Click button to load fles

8. Check the OK message (Load)
9. Click Auto Program button
10. If you see OK message (Verify), program download is completed.