How to Enter and Exit the Service Mode _ Sanyo Plasma Display _ PLASMA MONITOR PDP-42WV1_PDP-42WV1S (EUROPE, ASIA)
PDP42WV1A_ PDP-42WV1AS (U.S.A.)
SERVICE MODE
CAUTION
The each circuit has been made by the fine adjustment at
factory. Do not attempt to adjust the following adjustments except requiring
the readjustments in servicing otherwise it may cause loss of performance and
product safety.
Before Adjustment
This adjustment is done to enter Service Mode by Remote Control
Unit.
Quick operation is needed to enter Service Mode.
(1) Turn the monitor on.
(2) Press and hold the MENU button on the monitor.
(3) Keep item (2) and press the STATUS button and release
the both buttons.
(4) Within 2 seconds after item (3), press the MUTE button
to appear the Service Mode Display.
To return to the Normal Mode [Exit service mode]
Once turn the Monitor off by pressing “POWER” button on the
monitor or remote control unit and turn it on again.
SERVICE MODE DISPLAY
To adjust
* To select adjustment item, press ▲/▼ button on the remote
control unit.
* To adjust data, press ◄/► button on the remote control unit.
* Select adjustment item by ▲ button.
* Adjustment item is displayed in order. To reverse adjustment
item, press ▼ button.
* Adjust the data by ◄/►button.
To exit the Service Mode.
To exit the service mode, press POWER ONOFF button on the
monitor or remote control unit.
[The all data adjusted in service mode memorizes into
non-volatile memory IC.]
BATTERY REPLACEMENT
Plasma Monitor is used a battery for Clock Function. {Danger
of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.}
The battery is fixed to Main Board with Battery Holder.
* Remove the battery from battery holder to bent hooks
slightly.
* Mount a new battery by correct polarity and bent hooks back.
Parts No.: 645 059 8302
Chassis No. PDP-42WV1-00 (PDP-42WV1)
Chassis No. PDP-42WV1S-00 (PDP-42WV1S)
Chassis No. J3T-42WV1A00 (PDP-42WV1A)
Chassis No. J3T-42WV1AS00 (PDP-42WV1AS
