TO TAKE THE DISC OUT
Taking out the Disc from DVD-Drive Unit when the Disc cannot be ejected by OPEN/CLOSE button
Taking out the Disc from DVD-Drive Unit when the Disc cannot be ejected by OPEN/CLOSE button
* When the power can be turned
off: Turn off the power and press [STOP]
[CH UP] keys on the front panel simultaneously for 5 seconds.
* When the power cannot be turned
off: Press [POWER] key on the front
panel for over 10 seconds to turn off the power forcibly, and press [STOP] [CH
UP] keys on the front panel simultaneously
for 5 seconds.
When the Forcible Disc Eject cannot be done.
Caution: If you push strong and move the Slide Cam to
counter direction of the arrow, the stopper will be bended and Slide Cam won’t
stop at Stopper and will reach position for taking out Transverse Base. And transverse base might fall down later. Do not move Slide Cam in the counter direction
of the arrow. Moreover, the slide cam
will be on irregular position against condition of the shipment; if the tray is
pushed by the hand after manual tray ejection is done, the hold of transverse base
becomes imperfect, and the danger of fall of transverse base increases. Close the tray completely after manual tray
ejection was done. Especially finish
CLOSE function of try by electricity when the product will be transported after
inspection.
DMR-ES18EE / DMR-ES18GC /
DMR-ES18GCS / DMR-ES18GCA
* Turn off the power and pull out AC cord.
** Remove the Top Case.
*** Put deck so that bottom can be seen.
**** Remove the sheet of the bottom side.
***** Slide SLIDE CAM by Eject Pin (JZS0484) or minus screw driver
(small) in the direction of arrow to eject tray slightly.
****** Put deck upward, and push out Tray by Eject Pin (JZS0484) or
minus screw driver (small).