VESA specification. Function to implement the "Plug and Play" for automatically re configuring the user environment to directly use by exchanging the information with no direct command to the PC or the monitor from the user.
Device to use
PC (S/W included: EDID Data Write & Read)
EDID DOWNLOAD JIG
HDMI Cable, D-sub Cable.
Device configuration diagram for HDMI EDID Data input
1] Configure the download environment as shown at the adjustment
wiring diagram and turn on the PC.
2] Execute the DDC program. (EDID Data Write & Read)
3] Go to Model -> Open, and select the EDID data of the desired
model.
4] Check the item to download from the <Test> item
4-1] HDMI & RGB: Check Digital & Analog
4-2] (Only) HDMI: Check Digital only
5] Press ESC(Cancel Mode) -> F8(Auto Mode). (Set Auto Detecting)
6] Connect the desired signal cable to the set.
7] Make sure that the popup "Proceed to write?" is
displayed.
8] Press the Enter key or the space key to download.
9] After downloading, check the OK message and disconnect the
connected cable.
Note: Because downloading can be down at the
power on mode only, if it is not set, press the Power ON key of the remote
controller to proceed.
Click on the Tables to Zoom In
