STAND ASSEMBLY AND UNDER COVER – INVERTER – FACTORY RESET _ SONY KDL-32L504 [RM-YD028 REMOTE COTNROL]
* Gently place the TV set face down onto a soft cloth
* Remove 1 screw from Under Cover
* Remove 4 screws Table-Top Stand Assembly
* Slide Table-Top Stand Assembly out away from Bottom Bracket.
* Remove 1 screw from Under Cover
* Remove 4 screws Table-Top Stand Assembly
* Slide Table-Top Stand Assembly out away from Bottom Bracket.
SPEAKER REMOVAL
* Remove 1 screw from each Speaker Baffle Plate (2 total)
* Remove 4 screws from each loudspeaker (8 total)
* Disconnect speaker wire
* Remove 4 screws from each loudspeaker (8 total)
* Disconnect speaker wire
INVERTER BOARD REMOVAL
> Remove 5 screws from Board cover
> Pull out the Board from Lamp socket
> Pull out the Board from Lamp socket
Only remove the screws securing the inverter cover which may be
metal or plastic. The remaining plastic strip contains sockets for the fluorescent
backlights and should never be loosened. The backlights will pop out of the sockets
and/or break the backlight requiring a LCD panel replacement. The example shown
is a 32” model but applies to all models.
RESET TO FACTORY DEFAULT
Use the following instructions to restore the User Controls and Channel
Memory settings to the preset factory conditions.
* While holding down the ▲ on the Remote Commander, press the POWER button on the right side of the set.
The set restarts and displays the initial setup screen. This may take several minutes.
* While holding down the ▲ on the Remote Commander, press the POWER button on the right side of the set.
The set restarts and displays the initial setup screen. This may take several minutes.
CLICK ON THE PICTURES TO ZOOM IN