Keyboard_SDRAM_Hard disk drive & Optical drive removal –
Hp pavilion ZE1000 series notebook PCs.
To remove the keyboard and optical drive, proceed the
following order:
Battery => Lion 8-cell > F3410-60911
Drive, hard disk [20MB, 9.5mm, IBM (Diablo) ATA100 > 0950-4163
SDRAM, 128mb, PC133 SODIMM(x16) > 1818-8504
SDRAM, 256mb, PC133 SODIMM(X16) > 1818-8635
KEYBOARD > F3420-60913
DVD > F3410-60917
DVD,CD-RW > F3410-60919
BATTERY REMOVAL PROCEDURE
Slide the battery’s release latch,
and then pull the battery out of its compartment.
HARD DISK DRIVE
Remove both hard drive retaining
screws from the bottom of the notebook. Carefully
remove the hard drive from of the notebook.
Remove all four screws from the tray and drive case, and then remove the drive from the tray.
Remove all four screws from the tray and drive case, and then remove the drive from the tray.
(If you’re installing a new hard
disk drive, install the factory software and O/S on the drive before loading
any additional software.)
The notebook has no SDRAM built
into its motherboard, but has two slots for removable SDRAM modules in a
compartment on the bottom of the unit. (One of these slots contains a module
installed at the factory). You can use these slots to expand your unit’s RAM.
Use HP PC133 SDRAM modules only, or your notebook will not boot up.
Turn off the notebook: click
Start, Turn Off Computer, Turn Off.
Unplug the AC adapter (if present) and remove the notebook’s battery.
On the bottom of the notebook, loosen the screw holding the RAM cover (the cover retains the screw), and remove the cover.
Release the two latches at the sides of the SDRAM module by pushing them gently outward (away from the sides of the module). When you release the latches, the free edge of the module pops up.
Unplug the AC adapter (if present) and remove the notebook’s battery.
On the bottom of the notebook, loosen the screw holding the RAM cover (the cover retains the screw), and remove the cover.
Release the two latches at the sides of the SDRAM module by pushing them gently outward (away from the sides of the module). When you release the latches, the free edge of the module pops up.
KEYBOARD REMOVAL
Unplug the AC adapter, if present,
and remove the battery.
Use the flat-blade screwdriver to carefully pry up the right end of the keyboard cover, just above the Delete key, then lift the cover off of the notebook.
Use the flat-blade screwdriver to carefully pry up the right end of the keyboard cover, just above the Delete key, then lift the cover off of the notebook.
Insert the tabs on the left end of
the cover into the slots in the notebook’s case, and then gently press along
the length of the cover to snap it into place.
Remove both retaining screws from
the top of the keyboard.
Raise the top of the keyboard, then lift the keyboard up and out of the notebook, and lay it face down on the top case, forward of its normal position.
Raise the top of the keyboard, then lift the keyboard up and out of the notebook, and lay it face down on the top case, forward of its normal position.
OPTICAL DRIVE REMOVAL
Remove both retaining screws from
the back of the optical drive. 5. Carefully slide the optical drive out of the
notebook.