ADJUSTMENT PROCEDURES
Since a voltage is applied to the Main Power PCB heat sinks
while the set is operating, do not touch the heat sinks.
After the power cord plug was pulled out, do not pull out
the connector on the Main Power PCB until the Green LED (D531: Discharge check
LED) turns off.
- Disconnect CN6, CN23, CN33, CN42 and CN52
- Connect pin 1 and pin 13 of CN352 through a 1/4W, 1k resistor. Connect pin 1 of CN352 and pin 5 of CN509 through a 1/4W, 1k resistor. CN502 shorted.
- Press the power button.
ON THE MAIN POWER SUPPLY PCB [M02FQ]
