CONTROL PANEL AND SUPPRESSOR DISASSEMBLY - Electrolux ETW 10540W Top Loader Washing machine
CONTROL PANEL Disassembling
> Unlock
the control panel of side panel.
> Push
the control panel and slide it backward.
> Tilt
control panel upward.
> Unlock
the flat cable and the wires.
> Remove
the control panel.
Assembling
Insert guide bolt of the control panel into the guide runner at
the upper part.
Shift and lock control panel to the front.
The disassembling of the control panel gives access to,
> User interface
> Suppressor
> Analogue pressure switch
> Inlet valve
Electronic Disassembling
> Remove the control panel.
> Remove the three fixation screws from the electronic.
> Unlock the electronic from the rear panel. Disconnect all plugs.
Take care to the correct wiring when assembling
Supressor Disassembling
> Remove the control panel.
> Disassemble the suppressor.
Analogue pressure switch Disassembling
> Remove the left side panel.
> Detach hose clamp and pull off hose.
> Release pressure sensor.
> Release cable.
Air chamber Disassembling
> Remove the left side panel.
> Remove the one fixation screw from the electronic.
> Detach hose clamp and pull off hose.
> Release air trap and draw it off the tub.
Inlet valve Disassembling
> Unscrew the inlet hose.
> Remove the control panel.
> Remove the cover
> Unlock two wirings at the valves.
> Open two hose clamps at the water distributor.
> Pull off the two distribution hoses.
> Press in the clips using a screwdriver and turn the valve.
> Unlock the inlet valve.
During assembly you absolutely must assemble the cover because of
the splash guard.
