Friday, January 22, 2016

DA 3504 jBL - 4-3-2 CHANNEL AUTOMOTIVE POWER AMPLIFIER Schematic

Wiring diagram – Circuit Diagram jBL DA3504 – Car Audio Amplifier
4 Ohms Stereo => 35W x 4
2 Ohms Stereo => 50W x 4
4 Ohms Bridged => 100W x 2
Fuse Type => 30 Amp ATC
DC Operating Range => 9V – 18V
 All tests to be done, unless otherwise specified, from 20KHz to 20KHz at 14.4V DC into 4 ohm loads and adjust the units gain so that with a .775 volt input signal the unit is at its maximum rated output. All measurements will be done using an Audio precision system one and the supply voltage.
 An A+ line voltage of 14.4V DC shall be applied to the unit under test for all measurements unless otherwise specified. The voltage applied to the unit shall be measured at the power connection on the Amplifier.
 Unless otherwise specified, all tests shall be conducted with the Audio Signal Generator output configured to be balanced, less than or equal to 50 ohm source impedance, and floating. The signal source "GND" shall be connected to the Amplifier PWR GND at the Amplifier.
 Unless otherwise specified, all tests shall be conducted with 4 ohm resistive loads having less than 10% reactive components at any frequency below 75KHz. Each resistor shall have a value that remains within 1% while dissipating the rated output of the unit under test.
 Power Indicator LED steadily illuminates for normal operation. LED blinks when protection circuitry is engaged, and during power up.
WIRING DIAGRAM
CIRCUIT DIAGRAM (Schematic)
PWB - TOP VIEW
CLICK ON THE PICTURES TO MAGNIFY