How to program dish network with Emerson TV
- Press and Hold the desired Mode button [TV,VCR,SAT AUX] etc:-, for more than 3 seconds, until all Mode LEDs will stay lighted, and release the Mode button. [After start to synchronize, at any time if a button is not pressed within 20 seconds, the remote will reset itself, and you have to start from first. So, do not take more than 20 seconds between each press of an other button]
- Enter the three digit code for your device. The light will blink for each press of code button, and stay lighted.
- Press # button. If the entered code is valid, the respective Mode light will flash three times.
- To verify if the code entered is correct, try several other functions to the equipment.
- If the remote have only one button at the top, press the Mode button, until the button light stay lit.
- Using the tip of a ball point pen, press the Address button.
- Enter the code.
- Press the Address button. If the entered code is valid, the mode light will flash three times.
- To verify, try several other function to the device. Some codes may work for partial functions or respond differently. That is, if vol+ on the remote is pressed Channel down the function, and so on. In this case, try an other code. Choose one code, which have maximum functionality.
[Dish Network Codes for Emerson Brand TV are]
632_544_541_526_537_533_528_527_534_535_536_ 538_539_540_695_692_691_622_573_695_696_720_699
