When replacing the Main PBA and System Micom should be inserted the region code.
The set is not working properly if you don't insert the
region code.
The region code is inserted by the remote control.
- Press the “AUX” button on the remote control.
- Press the "TUNER MEMORY" button on the remote control during 4~5 seconds.
- After step (2), you can see “TEST” on the VFD.
- When you see “TEST” on VFD, Insert number “4”, “6” to start Region Code setting mode.
5. After step (4), you can see
“− −” on the VFD. Insert the Region Code (Below table)
corresponding model with “0 ~ 9” buttons on the remote control.
REGION CODE OPTION {Click on image to Enlarge}
- After step (5), you can see “15 USA” on the VFD. It means that currently System Micom program is installed by USA specification.
- Turn the Power off.
In case of System Micom and EEPROM problem, you can apply to
this.
For example, during Updating program of System Micom, if
Updating fail is happened, it is impossible to turn on the system from stand-by
status.
The system will keep the stand-by status continuously, and
the touch-key function will never work.
In this case, you have to change System Micom, and set up
the Buyer Region code again.
In case of EEPROM, you don't need to care about it.
After set-up the Region code, System Micom will store the
information of the region code to EEPROM automatically.
