Thursday, May 01, 2014

HOW TO ENTER SERVICE MODE - WHITE BALANCE ADJUSTMENT - SAMSUNG CW593CWG8XXEG - CW5944N8XXEC - CW5944W8XXEG - CW683CNG8XXEC


APPLICABLE TO SAMSUNG CW593CWG8XXEG - CW5944N8XXEC - CW5944W8XXEG - CW683CNG8XXEC CTV
SERVICE MODE
To enter the “Service Mode”, Press the remote-control keys in this sequence :
If you do not have Factory remote-control;
PICTURE OFF > DISPLAY > MENU > MUTE > PICTURE ON.
If you have Factory remote-control:
PICTURE ON > DISPLAY > FACTORY
  After the Service Mode is entered, the initial screen is as shown in the figure below.  (These hexa digits are check sum value which depends on the MICOM.  If check sum value is changed, the value ofE2PROM Data newly initialed.)
  Use the Channel Up/Down buttons to move the cursor in the adjustment parameters.  When CRT, CRT PCB, FBT, E2PROM (sometimes MICOM) is replaced, the adjustment values should be controlled.  After the Service adjustment is completed, Do not select “Reset” in the service mode menu. (After above procedure is done, power is on initially and the “Plug and Play” will be operated.)
MEMORY DATA: DEFLECTION (GEOMETRIC VALUE)
WHITE BALANCE ADJUSTMENT
1.  Select STANDARD from the menu.
2. Input an 100% White pattern.
3. Enter the “Service Mode”. 
4. Warm up the TV set at least for 30 minutes.
5. Input a Toshiba pattern signal.
6. Enter the “Video Adjust1”.
> Adjust “Sub Contrast” so that Y (luminance) becomes 40 ft ± 3.
> Use “Red Drive” and “ Blue Drive” to adjust High-Light (x : 290, y : 300)
> Adjust “Sub Bright” so that Y (luminance) becomes 1.3ft ± 0.3.
> Use “Red Cutoff” and “Blue Cutoff” to adjust Low-Light (x : 290, y : 300).
7. Adjust CA-100 so that the final adjustment value can be fixed.
8. Use the Channel Up/Down (/) buttons to move the cursor on the adjustment modes.
9. Use the Volume +/- buttons to change the adjustment value.
E2PROM (IC902) Replacement 
1.  When IC902 is replaced, all adjustment data revert to the initial values.  So, all adjustment values when servicing should be readjusted.
2. After IC902 is replaced, connect the AC power supply cord.
3.  Turn the power switch ON.
4.  In stand-by, warm up the TV for at least 10 seconds.
5.  Power on the TV.