HOW TO UPGRADE SOFTWARE [FIRMWARE]
Applicable to: Philips DVP3850K - DVP3820KX - DVP3850K - DVP3850K – DVP3250KG
To read out the software versions to confirm upgrading
1. Power on the set and press <Setup> button on the remote control.
Applicable to: Philips DVP3850K - DVP3820KX - DVP3850K - DVP3850K – DVP3250KG
Preparation to upgrade software
Start the CD Burning software and create a new CD project (Data Disc) with the following setting:
Start the CD Burning software and create a new CD project (Data Disc) with the following setting:
Label: DVP3XXX
(No need the label name) File Name: DVPXXXX_XX.BIN
Power on the
set and open the tray, then press <option> to check the File Name.
Note: It is
required capital letter for the File System name.
Burn
the data onto a blank CDR
Power on the set and insert the prepared
Upgrade CDR .
The set will starts reading disc &
response with the following display TV screen:
Upgrade File
DETECTED Upgrade?
Press Play TO
START.
Press
<OK> button to confirm, then screen will display :
Files coping…
UPGRADING…
The upgraded tray will
automatically open when files coping complete, then take out the disc.
About 1 minute later, the trace will
automatically close when upgrading
complete.To read out the software versions to confirm upgrading
1. Power on the set and press <Setup> button on the remote control.
2. Press <Next><Next><Prev><Prev> button. The software version and other information
are display on the TV screen as follows:
Version XX.XX.XX.XX (Main
version)
SUB-VER XX.XX.XX.XX (software
version of application software)
8032 XX.XX.XX.XX
Servo XX.XX.XX.XX (software
version of servo)
RIS XX.XX.XX.XX
DSP XX.XX.XX.XX
Region Code X
Caution: The set must not be
power off during upgrading, Otherwise the Main board will be damaged entirely.
SMPS [Power Supply Regulator] SCHEMATIC
PCB