Wednesday, June 11, 2014

COOLPIX L-10 NIKON DIGITAL CAMERA - DISASSEMBLE PROCEDURE - 2

Part-2
* Now examine the back face of the assembly , taking note of the six exposed screws. Remove these screws, and store them.
* Gently flip the LCD screen and its metal holding bracket up and over to expose the circuitry beneath it. Do not disconnect the LCD screen's large ribbon cable. But do notice the three small recessed screws, and the smaller ribbon cable and its connector. Remove the three screws.
* Now notice the black hinge on the small ribbon connector. Swivel this black hinge upward with your finger nail. The small ribbon should now easily pull free. Note that the cable has no connector on its end once it's pulled free.
* Very carefully tug and lift the bottom of the circuit board. It should hinge upward as the battery leads bend and serve as the hinge point.
* Remove the three screws on the metal cover plate over the lens assembly. Take extra care not to damage any circuit board components, especially the exposed CCD. After the screws are removed, the cover plate and lens assembly should now easily lift out.
* Pry the metal cover plate from the lens assembly. Do this by inserting a small screw driver under one of its three clips, and then twist it. The clip should pop free. Repeat on the other two clips until the plate is removed.
* Remove the four screws that hold its back cover on. Remove the back cover.
*Examine the interior of the lens assembly for any anomalies that may indicate its malfunction. In the below example, two things are apparent. First is that the assembly's guide pins have been dislocated from their intended guide grooves (look at the 4 and 8 O’clock positions). The second problem is that some of the teeth on the lens assembly's primary gear are missing and damaged (as seen at the 2 O’clock position).
Repair is possible by forcing the guide pins back into their grooves. However, camera operation would still be degraded due to the missing gear teeth. It would be necessary to physically help the lens extend and retract during power up/shutdown by pulling or pushing it. Because of this, it was decided to withhold repair and reassembly until acquiring another broken L10. The intent would to salvage and replace the lens assembly with an undamaged one.