Saturday, June 28, 2014

SHARP 25RM100 CTV - HOW TO ENTER SERVICE MODE - SMPS and Horizontal Out Circuit Diagram

Sharp 25RM100N color TV - Service mode entry_Power supply and Horizontal Output Circuit Diagram. How to initialize the settings
SERVICE MODE
* Before putting unit into the service mode, check that customer adjustments are in the normal mode. Use the reset function in the video adjustment menu to ensure customer controls are in  their  proper (reset) position.
* Once in  the  service  mode, press  the  Ch-up / Ch down  button  on  the  remote  controller  or  at  the  set.  The service adjustment number will vary in increments of one, from "S01" to "OP2.
* Press the Vol-up / down button to adjust the data number.
To enter the service mode and exit service mode.
# While pressing the Vol-up and Ch-up buttons at the same time, plug the AC cord into a wall socket.  Now the TV set is switched on and enters the service
mode.
# To exit the service mode, turn the television off by pressing the power button.
RF AGC Adjustment
1. Receive a good local channel.
2. Enter the service mode and select the service adjustment "S08".
3. Set the data value to point where no noise or beat appears.
4. Select another channel to confirm that no noise or beat appears.
Note 1 : You will  have to come out of the service mode to select another channel.
Note 2: Setting the data to "00" will produce a black raster.
How to initialize the TV
Holding  down  both  the  Vol-up/CH-down  buttons  on  the  TV  set  at  service  mode  for  more  than  2  seconds  will automatically write the above initial values into IC2101.
SMPS (Power Supply Regulator) & H-OUT SCHEMATIC _ CLICK ON THE PICTURES TO MAGNIFY