WIRING
Never allow any metal part of the amp's case, to come in contact with the metal body of the vehicle; to avoid an alternate 'Ground' connection other than specified by the wiring diagram. Use non conductive material to attach the Amp with vehicle. Do the same with all other attached devices with amplifier.
Note the
Ground point of Wiring. A Single Point
Ground is a must. Even though the
chassis of the vehicle as a whole is
(-ve), never connect the ground wire to other than specified point here. All the 4 ground wires should be connected to this
point, as shown in figure; otherwise, Audio Distortion will occur, especially
to higher volume levels.
1. It allows
left and right input channels to be connected to the amplifier using RCA plugs.
2. Speaker
Output Connector - Connect speaker wiring to these connectors.
3. Fuse - 40Ax3
Amp ATC type Fuses.
4. Power
Connection for 12V+, GND and REM connections for power wires.
5. Input-Level
Control - Adjusts input sensitivity for pre-amp level and speaker level inputs.
6. The
electronic crossover is a 12dB/oct. Low pass filter which can be set at any
frequency between 32Hz and 320Hz.
7. The bass
boost control will provide up to 6dB of boost at 50Hz.
8. It allows
left and right input channels such as high level speaker output signals to be
the amplifier.
9. The JBL BP
Series amplifiers can be mounted in virtually any location inside the vehicle. However, make sure to keep the amplifier away
from heater vents or ducts.
* At the
chosen site, use the amplifier as a mounting template and mark the locations of
the four mounting holes.
* Drill a
small pilot hole at each marked location.
* Mount the
amplifier and securely tighten the mounting screws. Never allow any metal part of the amp's case, to come in contact with the metal body of the vehicle; to avoid an alternate 'Ground' connection other than specified by the wiring diagram. Use non conductive material to attach the Amp with vehicle. Do the same with all other attached devices with amplifier.