Friday, June 20, 2014

ERROR CODES - FD Trintron - SONY KV-32FX66K - KV-28FX66E - HOW TO ENTER SERVICE MODE - ADJUSTMENTS

ERROR CODES
  The identification of errors within the AE-6B chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted) (See table), non fatal errors are reported using this method.
TO ENTER INTO TABLE-2
  1. Turn on the main power switch of the TV set.
  2. Program Remote Commander for Operation in Service Mode.
  3. Press ‘VIDEO’ ‘VIDEO’ > ‘MENU’ on the Remote Commander.
  4. Using the Remote Commander, Scroll to the ‘Error Menu’ item using the down arrow key, then press the right arrow key.  The following table will be displayed indicating the error count.
APPLICABLE TO 
KV-28FX66B [RM-937 FR SCC-Q83H-A]
KV-28FX66E [RM-937 ESP SCC-Q81K-A]
KV-28FX66U [RM-937 UK SCC-Q84F-A]
KV-32FX66B [RM-937 FR SCC-Q83G-A]
KV-32FX66E [RM-937 ESP SCC-Q81J-A]
KV-32FX66K [RM-937 OIRT SCC-Q82E-A]
KV-32FX66U [RM-937 UK SCC-Q84E-A]
Service adjustments to this model can be performed using the supplied remote Commander RM-937.
1. Press the VCR/TV/DVD button until the TV LED lights.
2. Press and hold the yellow button for approx. 5 seconds until the TV LED flashes quickly.
3. Press  99999. All three LED’s should light.  The remote commander is now set to Service Mode.
To return the remote commander to normal operation mode repeat steps 1. and 2. then press 00000. All three LED’s should light.  The remote commander is now set to normal mode.
Setting TV into Service Mode
Program the remote commander for operation in Service Mode as described above.
  1. Turn on the TV main power switch.
  2. Press the video standby button on the remote commander twice.  ‘TT ’ will appear in the upper right corner of the screen. Other status information will also be displayed.
  3. Press ‘MENU’ on the remote commander to obtain the following menu on the screen.
  4. Move to the corresponding adjustment item using the up or down arrow buttons on the Remote Commander.
  5. Press the right arrow button to enter into the required menu item.
  6. Press the ‘Menu’ button on the Remote Commander to quit the Service Mode when all adjustments have been completed.
Note:  After carrying out the service adjustments, to prevent the customer accessing the ‘Service Menu’ switch the TV set OFF and then ON.