HOW TO OPEN DENON CDR-W1500 CD RECORDER
Remove 4 screws (1) on both sides.
Remove 2 screws (2) on rear side.
Detach the top cover to the arrow direction.
Front panel
Turn the unit Power ON, and open both trays of the CD mechanism and CDR
mechanism.
Remove the loader panels and switch off the power after closing the trays. Disconnect the power plug.
Disconnect FFC of the display PWB from the Servo PWB, and unplug the
connectors on the H/P PWB and power SW PWB.
Remove 2 screws (3) and five screws (4).
Detach the front panel to the arrow direction. When unplugging the connectors on the Power
SW PWB, hold the PWB with your hand to prevent it from bending.
Mechanism unit
Fully open the tray by turning the gear under the mechanism unit
counterclockwise.
Remove 2 screws (5) through the hole of the tray.
Remove 2 screws (6) from the rear of the mechanism unit.
Detach the mechanism unit to the arrow
direction. Disassembling method of CD
and CDR mechanism are similar.
To disconnect the FFC
Push the FFC to the arrow direction.
With bending the holding part of the mechanism base as shown, release
the FFC to the arrow direction.
Each PWB
Power PWB
Remove 2 screws (7).
Remove 4 screws (8).
Remove 4 screws (9).
Audio PWB
Remove 8 screws (10)
Remove 2 screws (11).
Release on card spacer (12) to detach the PWB.
Servo PWB
Remove 2 screws (13).
Release 2 card spacers (14) to detach the PWB. When plugging the 6P PH-PH connector (CX061)
on the audio PWB, hold the PWB with your hand to prevent it from bending.
CLICK ON THE PICTURES TO MAGNIFY_If needy
