The identification of errors within the AE-6B chassis is
triggered in one of two ways :-
- Busy.
- Device failure to respond to IIC.
- In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted) See table 1, non fatal errors are reported using this method.
Each time the software detects an error it is stored
within the NVM.
Flash Timing Example: e.g. error number 3.
- Turn on the main power switch of the TV set.
- Program Remote Commander for Operation in Service Mode. [Visit previous post here for more details about Service Mode Entry]
- Press ‘VIDEO’ ‘VIDEO’ > ‘MENU’ on the Remote Commander.
- Using the Remote Commander, Scroll to the ‘Error Menu’ item using the down arrow key, then press the right arrow key.
- The following table will be displayed indicating the error count.
To clear the error count data press ‘80’ on the
Remote commander.
