Wednesday, October 30, 2013

SHARP LC-32D41U - LC-32M41U - LC-40C32U - SOFTWARE UPGRADE PROCEDURE


SOFTWARE UPGRADE
After replacement of any PWB unit and/or IC for repair, please note the following.
When replacing the following units, make sure to prepare the new units loaded with updated software.
MAIN Unit: DUNTKD640FM22 (LC-32D41U)
MAIN Unit: DUNTKD640FM23 (LC-32M41U)
MAIN Unit: DUNTKD640FM21 (LC-40C32U)
IF Unit: DUNTKD643FM22 (LC-32D41U)
IF Unit: DUNTKD643FM23 (LC-32M41U)
IF Unit: DUNTKD643FM18 (LC-40C32U)
Upgrading of each microprocessor software.
Caution: Never “POWER OFF” the unit when software upgrade is ongoing.  Otherwise the system may be damaged beyond recovery.
Software version upgrade. [The model employs the following software.]
Main software
Monitor microprocessor software
The main software and the monitor microprocessor software can be upgraded by using a general-purpose SD memory card.
The followings are the procedures for upgrading, explained separately for each of the main software, the monitor microprocessor software.
Main software version upgrade.
  • SD memory card of 32MB or higher capacity
  • PC running on Windows 98/98SE/ME/2000/XP operating system
  • SD memory card reader/writer with USB connectivity.
  • SD memory card formatting software. [ Can be downloaded by Panasonic website] Not by Sharp Website.
Preparations.
To upgrade the main software, it is necessary to get ready the SD card for version upgrade before you start.  Follow the steps below and create the SD card for version upgrade.
Insert the SD card into the SD card reader/writer.Start the SD card formatting software. Click [Format]. (When you have the drive options, select the drive where the SD card is inserted before you proceed.)
When the formatting is over, the following window appears. Click [OK].
Click [Exit] to finish the formatting.
NOTE: When you are done, take out the SD card once to make sure it is finished, and then insert it again.
Copy the binary image file D41(D41U, M41U, 40C32)UAxxx.SDC (named temporarily) for version upgrade to the root directory (folder) of the SD card drive.
NOTE: In the SD card drive, do not store other folders or unrelated files, or more than one binary image files for version upgrade.  Now the SD card for version upgrade is ready.
TO UPGRADE
  • Shut off the AC power (i.e. unplug the AC cord).
  • Insert the SD card for version upgrade (prepared as above) into the service socket located lower side from center at terminals, above S-VIDEO terminal in the rear of the unit, in a way that the cut corner of the SD card comes at the upper side.  NOTE: If the SD card is inserted in a wrong way, the card will go deep inside the unit beyond retrieval. Take due care to insert the SD card correctly.
  • Turn on the AC power (i.e. plug in the AC cord).
  • After the unit start-up, the system upgrade screen as shown below appears within 20-40 seconds.
Even a single failure in the process will trigger the upgrade failure screen as shown below. The word “NG” changes to red for the item failed.
NOTE: In the event of a failure, repeat the upgrading process. If the process repeatedly fails, it is likely that the hardware is troubled.
  • Upon completion of the whole process, the upgrade success screen as shown below appears. You can check the new software version on this screen. The version information appears after the upgrade is complete.
  • Shut off the AC power to the unit (unplug the AC cord), and remove the SD card for version upgrade.
  • Now the software version upgrade is complete.
NOTE: When you are done with the software version upgrade, start the set, go to the top page of the adjustment process screen and check the main software version information.