Sunday, December 29, 2013

PANASONIC KX-MB783-BR _ SERVICE CODES - TROUBLESHOOTING - INITIALIZATION


TO ENTER THE REMOTE PROGRAMMING MODE & CHANGING SERVICE CODES
If, after the call is connected, the customer describes the situation and it is determined that the problem can be corrected by making parameter changes, this function makes it possible to change parameters such as the user code and service code from another fax (using DTMF tones). Therefore, travel to the customer's location isn't required. However, it is not possible to change all the parameters remotely (PROGRAM MODE TABLE(P.98)). The function used to accomplish this is remote programming.
First, in order to check the current status of the service code parameter, print out the setup list (code: 991) and the service list (code: 999) from the customer's fax machine.
Based on this, the parameters for the desired codes can be changed.
The procedure for changing and listing parameters is described on ENTERING THE REMOTE PROGRAMMING MODE AND CHANGING SERVICE CODES. Also, before exiting the remote programming-mode, it is advisable to obtain a new list to confirm that the changes were made correctly.
HintSince the connected telephone is in use during the remote programming mode, it may be helpful to ask the customer to switch to the speaker phone. This frees the customer from the need to remain right next to the fax while you are making parameter settings. When finished, inform the customer. Also note that in very noisy locations where the DTMF tones are not audible, the remote programming function will not work.
ENTERING THE REMOTE PROGRAMMING MODE AND CHANGING SERVICE CODES.
CLICK ON THE TABLES TO ZOOM IN 
TROUBLESHOOTING
Troubleshooting is for recovering quality and reliability by determining the broken component and replacing, adjusting or cleaning it as required. First, determine the problem then decide the troubleshooting method. If you have difficulty finding the broken part, determine which board is broken. (For example: the Main PCB, Sensor PCB, etc.) The claim tag from a customer or dealer may use different expressions for the same problem, as they are not a technician or engineer. Using your experience, test the problem area corresponding to the claim. Also, returns from a customer or dealer often have a claim tag. For these cases as well, you need to determine the problem. Test the unit using the simple check list on SIMPLE CHECK LIST(P.104). Difficult problems may be hard to determine, so repeated testing is necessary.
Determine the symptom and the troubleshooting method.
INITIALIZATION
There are two types of initialization, one is the short initialization (about 3 seconds) and the other is the long initialization (about 10 seconds). The short initialization makes the unit enter the standby mode. The long initialization makes the unit enter the standby mode after cleaning or detecting the rest of toner.